5 Easy Ceiling Fan Installation and Maintenance Tips

So, you’re having a hard time feeding the fan wires through the pipe of your downrod? Maybe you are experiencing some wobbling with your fan. Want to save a little money? Change the direction of your fan depending upon the season. Learn to reduce the noise if your fan is loud. Double check the light bulbs to make sure your lighting is sufficient.

Ceiling fan installation can seem intimidating, but we’re here to give you five easy tips for how to install your ceiling fan.

Feeding Wires through a Long Downrod

Having a hard time feeding the fan wires through the pipe of your downrod? Try using good ol’ scotch tape or something similar to tape the wires to a thin wooden dowel rod. Simply drop the dowel rod through the pipe and the wires are fed through the pipe in less than a second. Don’t forget to remove all tape once the wires are fed through to the other side!

Troubleshooting Excessive Wobbling

You are experiencing some wobbling with your fan. No worries – it may just be a small error in the way the fan was installed. Try tightening all of the blade and blade iron screws until they are snug. You can also turn the power off, support the fan carefully, and check that the hanger ball (the top part of the downrod inside the canopy) is properly seated. If all else fails, use the balancing kit that was included with your fan and use the instructions to balance the fan.

Want to save a little money? We thought so.

During the warmer months, use your ceiling fan in the counterclockwise direction. It will help save you money on your electric bills by allowing you to adjust your thermostat to a higher temp. During the winter, change the ceiling fan direction to run in a clockwise direction on low speed. This will help circulate the warm air in the room. Just remember that a ceiling fan cools people, not rooms. You’ll want to turn your fan off when you leave the room to keep energy costs down.

No One Likes A Noisy Fan

You are experiencing a noisy fan (and possibly a mild case of insomnia). Try tightening the blade and blade iron screws until they are snug. You may also want to check and see if any of the blades are cracked. If they are, you must replace all of the blades. Why? Because over time, blades tend to droop down, and if you only change one of the blades, then it will be uneven with the rest and cause your fan to wobble.

Insufficient Light Output

Your lights dim when turned on or do not turn on at all. This is important – make sure the wattage of the light bulbs installed matches the specifications on the light sockets. It’s a simple solution that could make all the difference in the world.

Tips for how to clean your ceiling fan